I was just about to buy the needed routing bits from there:
http://www.t-molding.com/store/home.php?cat=6
But found them on Amazon a little cheeper...
The slot cutter is pretty nice.
I made the mistake of fitting it the wrong way round. It produced a lot of smoke - but still managed to cut a slot. Eventually I figured it out... :-)
It is a pain to get it 100% central - but experiment with a scrap bit of wood and some T-Moulding samples got it right. Once set I ran it all the way round. I think I messed up once - but corrected it. It is difficult to keep the router upright at times. Slowly does it!
No comments:
Post a Comment