Part 11: Fitting Speakers and Power Strip.

Now I have the black paint - I could start fitting things.

I needed power - so I drilled out a large hole and found a grommet to fit in there. I unsoldered the cable from the power strip and then soldered it back once the cable was through the hole.

Here is the only picture I took - you can see an inside view - the grommet and the bottom casing of the power strip fitted in place. I added the rest of the power strip later...

I fitted the speakers. They don't look too great here, but I dusted them up and added black paint to the screws. They look much better now...

I wired them up here. The frequency cross over circuit for the tweaters consisted of a single capacitor. 

Thankfully the clearance for the strip light was ok...